This fixed-price listing includes the the PAC-AP4-CH21 Advanced Amplifier Integration Interface & the APA-TOS1 TOSLINK optical output for Chrysler, Dodge, and Jeep models. AmpPRO simplifies the installation of upgraded amplifiers in data-bus controlled sound systems. With AmpPRO, you can improve audio performance while keeping an original radios fit, finish and features. The APA-TOS1 is a fiber-optic audio output add-on module for use with PAC AmpPRO interfaces. The APA-TOS1 quickly and easily installs in your AmpPRO interface and provides a digital TOSLINK output.
Connect any brand and length of TOSLINK cable, and you are ready to connect a TOSLINK equipped DSP, or amplifier into the vehicle. PAC AP4-CH21 Amplifier integration system. PAC APA-TOS1 Fiber-optic Audio Output (optical cable not included).General Installation and Operation Instructions. This interface is only compatible in vehicles equipped with a data-bus controlled premium sound system. To verify compatibility, look for an Alpine, Beats, or Harmon Kardon badge on the door speakers, center speaker, or factory subwoofer. If none of these brands are shown, check for the presence of a center speaker or subwoofer. Compatibility Requirements for the APA-TOS1 Fiber Optic Adapter.
Professional installation is strongly advised. A TOSLINK cable is needed but not included.Just for use in conjunction with the AP4 interface. The installation of this product requires the disassembly of the AP4 interface. The audio component to be used with the APA-TOS1 must be equipped with a TOSLINK fiber optic audio input. (S/PDIF 2 channel uncompressed PCM audio). Variable volume, fade, balance, bass, mid and treble audio settings. Front, rear, sub preamp outputs (5 volt RMS). Provides flat audio output for a solid audio foundation. Customized OE bass, mid and treble center frequency selection.
Retains uConnect, Bluetooth audio and all warning chimes. Provides a digital fiber-optic variable audio signal output. Compatible with TOSLINK equipped DSPs or amplifiers. Digital audio signals are less susceptible to noise or interference. Prevents need for summing and DSP devices.
Provides factory sound system upgrade solution. The factory amplifier must remain connected, and in the vehicle after the AmpPRO has been installed. The remote output is rated at 2A of current. If more current is needed an external relay must be used.Channels 5 and 6 are non-fading outputs. The output level of channels 5 and 6 can be controlled using the supplied level control knob. The minimum volume level is set to 0 dB by default. If you are happy with this level in your particular application then additional adjustment is not required. Please refer to the Setup and Configuration section on page 2 for more details. The level control knob must be connected in order to manually adjust the minimum volume setting. No adjustments can be made manually using the programming button, or the factory SWC when the module is connected to a PC. Only compatible with the above listed vehicles. This is what most consider is the hardest part of the installation.
With this diagram; installation is a piece of cake. Vehicles NOT made for the U. Market are not compatible and are not guaranteed. The item "PAC Advanced Amplifier Integration Interface with Fiber-Optic Output Toslink" is in sale since Wednesday, April 26, 2017. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Interior\Dash Parts".
1" and is located in Miami, Florida. This item can be shipped worldwide.